3Com WXR100 3CRWXR10095A Video Game Controller User Manual


 
718 CHAPTER 23: SYSTEM LOG COMMANDS
If you do not specify a local facility, MSS sends the messages with their
default MSS facilities. For example, AAA messages are sent with
facility 4 and boot messages are sent with facility 20 by default.
enable — Enables messages to the specified target.
disable — Disables messages to the specified target.
Defaults — The following are defaults for the set log commands.
Events at the error level and higher are logged to the WX console.
Events at the error level and higher are logged to the WX system
buffer.
Trace logging is enabled, and debug-level output is stored in the WX
trace buffer.
Access — Enabled.
History — Introduced in MSS Version 3.0. Version 4.2 added the option
port.
Usage — Using the command with only enable or disable turns logging
on or off for the target at all levels. For example, entering set log buffer
enable with no other keywords turns on logging to the system buffer of
all facilities at all levels. Entering set log buffer disable with no other
keywords turns off all logging to the buffer.
Examples — To log only emergency, alert, and critical system events to
the console, type the following command:
WX4400# set log console severity critical enable
success: change accepted.
See Also
display log config on page 714
clear log on page 711