Filter
Top Products
display log trace 715
display log trace Displays system information stored in the nonvolatile log buffer or the
trace buffer.
Syntax —
display log trace [{+|-|/}number-of-messages]
[facility facility-name] [matching string]
[severity severity-level]
trace — Displays the log messages in the trace buffer.
+|-|/number-of-messages — Displays the number of messages
specified as follows:
A positive number (for example, +100), displays that number of log
entries starting from the oldest in the log.
A negative number (for example, -100) displays that number of log
entries starting from newest in the log.
A number preceded by a slash (for example, /100) displays that
number of the most recent log entries in the log, starting with the
least recent.
facility facility-name — Area of MSS that is sending the log
message. Type a space and a question mark (?) after display log
trace facility for a list of valid facilities.
matching string — Displays messages that match a string—for
example, a username or IP address.
severity severity-level — Displays messages at a severity level
greater than or equal to the level specified. Specify one of the
following:
emergency — The WX switch is unusable.
alert — Action must be taken immediately.
critical — You must resolve the critical conditions. If the
conditions are not resolved, the WX can reboot or shut down.
error — The WX is missing data or is unable to form a connection.
warning — A possible problem exists.
notice — Events that potentially can cause system problems have
occurred. These are logged for diagnostic purposes. No action is
required.
info — Informational messages only. No problem exists.
debug — Output from debugging.