Filter
Top Products
450 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
set service-profile
mesh
Creates a service profile for use with WLAN mesh services.
Syntax —
set service-profile name mesh mode
{enable | disable}
name — Service profile name.
enable — Enables mesh services for the service profile.
disable — Disables mesh services for the service profile.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 6.0.
Usage — Use this command to configure mesh services for a service
profile. Once configured, the service profile can then be mapped to a
radio profile that manages a radio on the Mesh Portal MAP, which
then allows a Mesh Portal AP to beacon a mesh services SSID to Mesh
APs.
Examples — The following command enables mesh services for service
profile sp1:
WX# set service-profile sp1 mesh mode enable
success: change accepted.
See Also
display ap mesh-links on page 329
set ap boot-configuration mesh ssid on page 373