Filter
Top Products
288 CHAPTER 9: MOBILITY DOMAIN COMMANDS
Examples — The following command configures this WX as the
secondary seed in a
Mobility Domain named Pleasanton:
WX# set mobility-domain mode secondary-seed domain-name
Pleasanton
mode is: secondary-seed
domain name is: Pleasanton
See Also
clear mobility-domain member on page 280
display mobility-domain on page 281
set
mobility-domain
mode seed
domain-name
Creates a Mobility Domain by setting the current WX as the seed device
and naming the Mobility Domain.
Syntax —
set mobility-domain mode seed domain-name
mob-domain-name
mob-domain-name — Name of the Mobility Domain. Specify between
1 and 32 characters with no spaces.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0. Version 4.2 increased the
maximum length of mob-domain-name to 32 characters.
Usage — Before you use this command, the current WX must have its IP
address set with the set system ip-address command. After you enter
this command, all Mobility Domain traffic is sent and received from the
specified IP address.
You must explicitly configure only one WX switch per domain as the seed.
All other WX switches in the domain receive their Mobility Domain
information from the seed.
Examples — The following command creates a Mobility Domain named
Pleasanton with the current WX as the seed:
WX4400# set mobility-domain mode seed domain-name Pleasanton
mode is: seed
domain name is: Pleasanton