Filter
Top Products
Exiting the AMP Appliance Management Panel
62
590-590-609A
If this is the first time a unit has been accessed since the KVM s3 Client was
started, a user name and password prompt opens.
a. Type in your user name and password. [If this is the first appliance access
since initialization or reinitialization, the default user name is Admin (case
sensitive) with no password.]
b. Click OK to log in, or click Cancel to exit without logging in.
The AMP opens.
5.1.2 Exiting the AMP
Complete one of the following steps
Click OK to save any changes and exit the AMP.
-or-
Click Cancel to exit the AMP without saving any changes.
5.2 Managing Global settings
The Global category lists the appliance product type, its serial number, and the
language the appliance is currently using. Use the Global category to configure network
settings, session settings, virtual media settings, and authentication settings.
5.2.1 Configuring Global Network settings
The Global - Network subcategory enables you to view and configure the IP address,
subnet mask and gateway DNS servers (all read-only if DHCP is enabled), MAC
address (read-only), LAN interface speed, and DHCP state (enabled or disabled) of the
appliance. The appliance name is also listed. The name is read-only in this sub-
category; you can change the appliance name in the SNMP category.
5.2.1.1 Changing global network values
Click the Settings tab in the AMP.
Select the Global - Network subcategory.