3Com WX1200 3CRWX120695A Video Game Controller User Manual


 
set port speed 95
History — Introduced in MSS Version 3.0.
Usage — This command does not apply to any gigabit Ethernet ports or
to ports 7 and 8 on the WX1200 switch.
Examples — The following command disables PoE on ports 4 and 5,
which are connected to a MAP access point:
WX1200# set port poe 4,5 disable
If you are enabling power on these ports, they must be connected only to approved
PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y
The following command enables PoE on ports 4 and 5:
WX1200# set port poe 4,5 enable
If you are enabling power on these ports, they must be connected only to approved
PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y
See Also
set port type ap on page 97
set port type wired-auth on page 100
set port speed Changes the speed of a port.
Syntaxset port speed port-list {10 | 100 | 1000 | auto}
port-list — List of physical ports. MSS sets the port speed on all the
specified ports.
10 — Sets the port speed of a 10/100 Ethernet port to 10 Mbps and
sets the operating mode to full-duplex.
100 — Sets the port speed of a 10/100 Ethernet port to 100 Mbps
and sets the operating mode to full-duplex.
1000 — Sets the port speed of a gigabit Ethernet port to 1000 Mbps
and sets the operating mode to full-duplex.
auto — Enables a port to detect the speed and operating mode of the
traffic on the link and set itself accordingly.
Defaults — All ports are set to auto.
Access — Enabled.
History — Introduced in MSS Version 3.0.