Filter
Top Products
display ap status 331
See Also
set ap boot-configuration mesh ssid on page 373
set service-profile mesh on page 450
display ap status Displays MAP access point and radio status information.
Syntax — display ap status [terse] [ap-number | all [radio
{1 | 2}]]
terse — Displays a brief line of essential status information for each
MAP.
ap-number — Index value that identifies the MAP on the WX.
all — Shows status information for all directly attached MAP access
points and all Distributed MAP access points configured on the switch.
radio 1 — Shows status information for radio 1.
radio 2 — Shows status information for radio 2. (This option does
not apply to single-radio models.)
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0. True base MAC addresses of
radios are displayed in MSS Version 3.2. Previously, the base MAC address
displayed for a radio was the true base MAC address plus 2. Note that a
radio’s base MAC address is also used as the BSSID of the first SSID
configured on the radio. New option added: terse; new option added for
display ap status: all; new field added: fingerprint; MAP-WX security
status added to State field in MSS Version 4.0. External antenna
information added after the radio state information, to indicate when an
antenna has been detected and to indicate the configured antenna
model number; auto flag added to indicate operational channel or power
settings that are configured by RF Auto-Tuning in MSS Version 4.1.
Version 4.2 added Radar Scan and Radar Detected flags to indicate when
the Dynamic Frequency Selection (DFS) feature is scanning for radar or
has stopped transmitting due to detected radar. The flags apply to
802.11a radios only, and only for country codes where DFS is used.
Version 6.0 removed the dap option.