Filter
Top Products
set radio-profile auto-tune power-interval 407
Examples — The following command enables dynamic power tuning for
radios in the rp2 radio profile:
WX4400# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
See Also
display radio-profile on page 350
set ap radio auto-tune max-power on page 384
set ap radio auto-tune max- retransmissions on page 385
set radio-profile auto-tune channel-config on page 402
set radio-profile auto-tune power-interval on page 407
set radio-profile
auto-tune
power-interval
Sets the interval at which RF Auto-Tuning decides whether to change the
power level on radios in a radio profile. At the end of each interval, MSS
processes the results of the RF scans performed during the previous
interval, and changes radio power levels if needed.
Syntax —
set radio-profile name auto-tune
power-interval seconds
name — Radio profile name.
seconds — Number of seconds MSS waits before changing radio
power levels to adjust to RF changes, if needed. You can specify from
1 to 65535 seconds.
Defaults — The default power tuning interval is 600 seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command sets the power interval for radios
in radio profile rp2 to 240 seconds:
WX4400# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.