Filter
Top Products
704 CHAPTER 22: SNOOP COMMANDS
set snoop map Maps a snoop filter to a radio on a MAP. A snoop filter does take effect
until you map it to a radio and enable the filter.
Syntax —
set snoop map filter-name ap ap-num radio {1 | 2}
filter-name — Name of the snoop filter.
ap ap-num — Number of a MAP to which to map the snoop filter.
radio 1 — Radio 1 of the MAP.
radio 2— Radio 2 of the MAP. (This option does not apply to
single-radio models.)
Defaults — Snoop filters are unmapped by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — You can map the same filter to more than one radio. You can
map up to eight filters to the same radio. If more than one filter has the
same observer, the MAP sends only one copy of a packet that matches a
filter to the observer. After the first match, the MAP sends the packet and
stops comparing the packet against other filters for the same observer.
If the filter does not have an observer, the MAP still maintains a counter
of the number of packets that match the filter. (See display snoop stats
on page 708.)
Examples — The following command maps snoop filter snoop1 to radio
2 on MAP 3:
WX1200# set snoop map snoop1 ap 3 radio 2
success: change accepted.
See Also
clear snoop map on page 700
display snoop map on page 707
display snoop stats on page 708
set snoop on page 701
set snoop mode on page 705