3Com WX1200 3CRWX120695A Video Game Controller User Manual


 
380 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
If local switching is enabled on an MAP, but no VLAN profile is
configured, then a default VLAN profile is used. The default VLAN profile
includes a single VLAN named default that is not tagged.
ExamplesThe following command enables local switching for MAP
7:
WX# set ap 7 local-switching mode enable
success: change accepted.
See Also
set ap local-switching vlan-profile on page 380
set vlan profile on page 127
set ap
local-switching
vlan-profile
Applies a specified VLAN profile to an MAP to use with local switching.
Syntaxset ap ap-number local-switching vlan-profile
profile name
ap-number — Index value that identifies the MAP on the WX.
profile-name — The name of a VLAN profile configured on the WX.
Defaults If local switching is enabled on an MAP, but no VLAN
profile isconfigured, then a default VLAN profile is used. The default
VLAN profile
includes a single VLAN named default that is not tagged.
AccessEnabled.
History Introduced in MSS Version 6.0.
History A VLAN profile consists of a list of VLANs and tags. When a
VLAN
profile is applied to an MAP, traffic for the VLANs specified in the
VLAN profile is locally switched by the MAP instead of being tunneled
back to an WX.
When applying a VLAN profile causes traffic that had been tunneled to an
WX to be locally switched by MAPs, or vice-versa, the sessions of clients
associated with the MAPs where the VLAN profile is applied are
terminated, and the clients must re-associate with the MAPs.