Filter
Top Products
set service-profile auth-dot1x 433
See Also
display service-profile on page 353
display sessions network on page 620
set service-profile
auth-dot1x
Disables or reenables 802.1X authentication of Wi-Fi Protected Access
(WPA) clients by MAP radios, when the WPA information element (IE) is
enabled in the service profile that is mapped to the radio profile that the
radios are using.
Syntax —
set service-profile
name auth-dot1x {enable | disable}
name — Service profile name.
enable — Enables 802.1X authentication of WPA clients.
disable — Disables 802.1X authentication of WPA clients.
Defaults — When the WPA IE is enabled, 802.1X authentication of WPA
clients is enabled by default. If the WPA IE is disabled, the auth-dot1x
setting has no effect.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command does not disable dynamic WEP for non-WPA
clients. To disable dynamic WEP for non-WPA clients, enable the WPA IE
(if not already enabled) and disable the 40-bit WEP and 104-bit WEP
cipher suites in the WPA IE, if they are not already disabled.
To use 802.1X authentication for WPA clients, you also must enable the
WPA IE.
If you disable 802.1X authentication of WPA clients, the only method available
for authenticating the clients is preshared key (PSK) authentication. To use this,
you must enable PSK support and configure a passphrase or key.
Examples — The following command disables 802.1X authentication for
WPA clients that use service profile wpa_clients:
WX4400# set service-profile wpa_clients auth-dot1x disable
success: change accepted.