Filter
Top Products
312 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
clear radio-profile Removes a radio profile or resets one of the profile’s parameters to its
default value.
Syntax —
clear radio-profile name [parameter]
name — Radio profile name.
parameter — Radio profile parameter:
beacon-interval
countermeasures
dtim-interval
frag-threshold
max-rx-lifetime
max-tx-lifetime
preamble-length
rts-threshold
service-profile
For information about these parameters, see the set radio-profile
commands that use them.
Defaults — If you reset an individual parameter, the parameter is
returned to the default value listed in Table 72 on page 416.
Access — Enabled.
History —Introduced in MSS Version 3.0. countermeasure parameter
added in Version 4.1. Version 4.2 removes the long-retry and
short-retry parameters that no longer apply to radio profiles.
Usage — If you specify a parameter, the setting is reset to its default
value. The settings of the other parameters are unchanged and the radio
profile remains in the configuration. If you do not specify a parameter,
the entire radio profile is deleted from the configuration. All radios that
use this profile must be disabled before you can delete the profile.
Examples — The following commands disable the radios using radio
profile rp1 and reset the beaconed-interval parameter to its default
value:
WX4400# set radio-profile rp1 mode disable
WX4400# clear radio-profile rp1 beacon-interval
success: change accepted.