Filter
Top Products
390 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
disable — Disables link calibration packets for the MAP radio.
Defaults — Disabled.
Access — Enabled.
History — Introduced in MSS Version 6.0.
Usage — By default, RF load balancing is enabled on all MAP radios.
Use this
command to disable or re-enable RF load balancing for the
specified MAP radio.
RF load balancing can also be disabled or re-enabled globally with the set
load-balancing mode command. If RF load balancing has been enabled
or disabled for a specific MAP radio, then the setting for the individual
radio takes precedence over the global setting.
Examples — The following command disables RF load balancing for
MAP radio 1 on
MAP 7:
WX# set ap 7 radio 1 load-balancing disable
WX#
See Also
set load-balancing strictness on page 399
clear ap radio load-balancing group on page 311
set ap local-switching mode on page 379
display load-balancing group on page 348
set ap radio load
balancing group
Assigns an MAP radio to a load balancing group.
Syntax — set ap ap-number radio {1 | 2} load-balancing group
name [rebalance]
ap ap-number — Index value that indentifies the MAP on the WX.
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
group name — Name of an RF load balancing group to which the
MAP radio
is assigned. A radio can belong to only one group.