Filter
Top Products
184 CHAPTER 7: IP SERVICES COMMANDS
set ntp server Configures a WX to use an NTP server.
Syntax —
set ntp server ip-addr
ip-addr — IP address of the NTP server, in dotted decimal notation.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can configure up to three NTP servers. MSS queries all the
servers and selects the best response based on the method described in
RFC 1305, Network Time Protocol (Version 3) Specification,
Implementation and Analysis.
To use NTP, you also must enable the NTP client with the set ntp
command.
Examples — The following command configures a WX switch to use
NTP server 192.168.1.5:
WX4400# set ntp server 192.168.1.5
See Also
clear ntp server on page 141
clear ntp update-interval on page 142
display ntp on page 159
set ntp on page 183
set ntp update-interval on page 185