Filter
Top Products
clear ip telnet 141
clear ip telnet Resets the Telnet server TCP port number to its default value. A WX
listens for Telnet management traffic on the Telnet server port.
Syntax —
clear ip telnet
Defaults — The default Telnet port number is 23.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command resets the TCP port number for
Telnet management traffic to its default:
WX4400# clear ip telnet
success: change accepted.
See Also
display ip https on page 155
display ip telnet on page 158
set ip https server on page 177
set ip telnet on page 181
set ip telnet server on page 182
clear ntp server Removes an NTP server from a WX configuration.
Syntax — clear ntp server {ip-addr | all}
ip-addr — IP address of the server to remove, in dotted decimal
notation.
all — Removes all NTP servers from the configuration.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.