Filter
Top Products
196 CHAPTER 7: IP SERVICES COMMANDS
Usage — The inform or trap option specifies whether the MSS SNMP
engine expects the target to acknowledge notifications sent to the target
by the WX switch. Use inform if you want acknowledgements. Use trap
if you do not want acknowledgements. The inform option is applicable
to SNMP version v2c or usm only.
Examples — The following command configures a notification target for
acknowledged notifications:
WX1200# set snmp notify target 1 10.10.40.9 usm inform user
securesnmpmgr1 snmp-engine-id ip
success: change accepted.
This command configures target 1 at IP address 10.10.40.9. The target’s
SNMP engine ID is based on its address. The MSS SNMP engine will send
notifications based on the default profile, and will require the target to
acknowledge receiving them.
The following command configures a notification target for
unacknowledged notifications:
WX1200# set snmp notify target 2 10.10.40.10 v1 trap
success: change accepted.
See Also
clear snmp notify target on page 144
set ip snmp server on page 180
set snmp community on page 185
set snmp notify profile on page 187
set snmp protocol on page 197
set snmp security on page 198
set snmp usm on page 199
display snmp notify target on page 162