Filter
Top Products
158 CHAPTER 7: IP SERVICES COMMANDS
See Also
clear ip route on page 140
display interface on page 152
display vlan config on page 118
set interface on page 170
set ip route on page 178
display ip telnet Shows information about the Telnet management port.
Syntax — display ip telnet
Defaults — None.
Access — All.
History —Introduced in MSS Version 3.0.
NH-Type Next-hop type:
Local — Route is for a local interface. MSS adds the route
when you configure an IP address on the WX.
Direct — Route is for a locally attached subnet. MSS adds
the route when you add an interface in the same subnet to
the WX.
Router — Route is for a remote destination. A WX switch
forwards traffic for the destination to the gateway router.
Gateway Next-hop router for reaching the route destination.
This field applies only to static routes.
VLAN:Interface Destination VLAN, protocol type, and IP address of the route.
Because direct routes are for local interfaces, a destination IP
address is not listed.
The destination for the IP multicast route is MULTICAST.
For static routes, the value Down means the WX does not have
an interface to the destination next-hop router. To provide an
interface, configure an IP interface that is in the same IP subnet
as the next-hop router. The IP interface must be on a VLAN with
the port attached to the default router.
Table 37 Output of display ip route (continued)
Field Description