3Com WX1200 3CRWX120695A Video Game Controller User Manual


 
658 CHAPTER 19: RF DETECTION COMMANDS
History —Introduced in MSS Version 3.0.
Usage — This command is valid only on the seed switch of the Mobility
Domain.
The log messages for rogues are generated only on the seed and appear
only in the seed’s log message buffer. Use the display log buffer
command to display the messages in the seed switch’s log message
buffer.
Examples — The following command enables RF detection logging for
the Mobility Domain managed by this seed switch:
WX1200# set rfdetect log enable
success: rfdetect logging is enabled.
See Also
display log buffer on page 712
set rfdetect
signature
Enables MAP signatures. A MAP signature is a set of bits in a
management frame sent by a MAP that identifies that MAP to MSS. If
someone attempts to spoof management packets from a 3Com MAP,
MSS can detect the spoof attempt.
Syntax
set rfdetect signature {enable | disable}
enable — Enables MAP signatures.
disable — Disables MAP signatures.
Defaults — MAP signatures are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — The command applies only to MAPs managed by the WX
switch on which you enter the command. To enable signatures on all
MAPs in a Mobility Domain, enter the command on each WX switch in
the Mobility Domain.
You must use the same MAP signature setting (enabled or disabled) on all
WX switches in a Mobility Domain.