3Com WX1200 3CRWX120695A Video Game Controller User Manual


 
394 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
tx-power power-level — Number of decibels in relation to
1 milliwatt (dBm). The valid values depend on the country of
operation.
The maximum transmit power you can configure on any 3Com radio
is the maximum allowed for the country in which you plan to operate
the radio or one of the following values if that value is less than the
country maximum: on an 802.11a radio, 11 dBm for channel numbers
less than or equal to 64, or 10 dBm for channel numbers greater than
64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for
802.11b, or 14 dBm for all valid channel numbers for 802.11g.
Defaults — The default transmit power on all MAP radio types is the
highest setting allowed for the country of operation or highest setting
supported on the hardware, whichever is lower.
Access — Enabled.
History —Introduced in MSS Version 3.0. Version 6.0 removed the dap
option.
Usage — You also can configure a radio channel on the same command
line. Use the channel option.
This command is not valid if dynamic power tuning (RF Auto-Tuning) is
enabled.
Examples — The following command configures the transmit power on
the 802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 tx-power 10
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
display ap config on page 316
set ap radio channel on page 387