Filter
Top Products
528 CHAPTER 13: IGMP SNOOPING COMMANDS
set igmp mrsol Enables or disables multicast router solicitation by a WX.
Syntax —
set igmp mrsol {enable | disable} [vlan vlan-id]
enable — Enables multicast router solicitation.
disable — Disables multicast router solicitation.
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, multicast router solicitation is disabled or enabled on all VLANs.
Defaults — Multicast router solicitation is disabled on all VLANs by
default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command enables multicast router
solicitation on VLAN orange:
WX1200# set igmp mrsol enable vlan orange
success: change accepted
See Also
set igmp mrsol mrsi on page 528
set igmp mrsol mrsi Changes the interval between multicast router solicitations by a WX on
one VLAN or all VLANs.
Syntax —
set igmp mrsol mrsi seconds [vlan vlan-id]
seconds — Number of seconds between multicast router solicitations.
You can specify a value from 1 through 65,535.
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, MSS changes the multicast router solicitation interval for all
VLANs.
Defaults — The interval between multicast router solicitations is 30
seconds by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.