Filter
Top Products
6F3B0250
Basic Hardware and Function
71
4. Installation and Wiring
4.3 Wiring terminals
The terminal arrangement of each T1 Series model are shown below.
The terminal screw size is M3.5. Use crimp-style terminals of 7 mm width or less useable
for M3.5.
The terminal blocks of the T1-16 are not removable (fixed). On the other hand, the
terminal blocks of the T1-28, T1-40 and T1-40S are removable. However, be sure to turn
off power before removing or replacing the terminal blocks.
·
T1-16
T1-MDR16 ... AC power supply, Dry contact input type
!
CAUTION
NOTE
1. Turn off power before wiring to minimize the risk of electrical shock.
2. Exposed conductive parts of wire can cause electrical shock. Use
crimp-style terminals with insulating sheath or insulating tape to cover
the conductive parts. Also close the terminal covers securely on the
terminal blocks when wiring has been completed.
3. Turn off power before removing or replacing units, modules, terminal
blocks or wires. Failure to do so can cause electrical shock or damage
to the T1/T1S and related equipment.
For input and output signal connections, refer to sections 2.4 and 3.
6420L
7531
-
N
27252321
Vin
+
C1
26242220
C0
T1-16
IN
OUT
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net