Filter
Top Products
6F3B0250
26
T1/T1S User’s Manual
1. System Configuration
Operation status LEDs:
Indicate the operation status of the T1/T1S.
PWR PWR
RUN RUN
FLT FLT
AUX
T1-16 / T1-28 T1-40 / T1-40S
PWR Lit Internal 5 Vdc power is normal.
(Power) (green) Not lit Internal 5 Vdc power is not normal.
Lit RUN mode (in operation)
RUN (green) Blinking HOLD mode
Not lit HALT mode or ERROR mode
FLT Lit ERROR mode
(Fault) (red) Blinking Hardware error (programmer cannot be connected)
Not lit Normal
AUX
(Auxiliary) (red)
-
Can be controlled by user program. Lit when S320 is
ON and unlit when S320 is OFF. (T1-40/T1-40S)
Mode control switch:
Controls the operation modes of the T1/T1S.
H (HALT) When the switch is turned to H (HALT) side, the T1/T1S stops
program execution (HALT mode). In this position, RUN/HALT
command from the programmer is disabled. In case of the T1,
programming is available only in the HALT mode.
R (RUN) When the switch is turned to R (RUN) side, the T1/T1S starts program
execution. This is the position during normal operation.
In this position, RUN/HALT command from the programmer is also
available.
Analog setting adjusters:
Two analog setting adjusters are provided. The V0 value is stored in SW30 and the V1
value is stored in SW31. The converted value range is 0 to 1000. Refer to section 8.5
for details of the analog setting function.
Programmer port connector:
Used to connect the programmer cable. The interface is RS-232C. This port can also
be used for the computer link function. Refer to section 1.6 for more information about
the computer link function.
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net