Filter
Top Products
Front Panel Operation - 5
47
System Keys
Refer to the examples later in this chapter for more details on the use of these keys.
Local
Address
Recall
Save
Error
SYSTEM
Channel
Figure 5-2. System Keys
This is the blue, unlabeled key, which is also shown as in this guide.
Pressing this key accesses the alternate or shifted function of a key (such as
ERROR ). Release the key after you press it. The Shift annunciator is lit,
indicating that the shifted keys are active.
Press to change the dc source's selected interface from remote operation to local
(front panel) operation. Pressing the key will have no effect if the interface state
is already Local, Local-with-Lockout, or Remote-with-Lockout.
Press to access the address menu. All entries are stored in non-volatile memory.
Display Command Function
ADDRESS <value> Sets the GPIB Address
LANG <char> Selects language (SCPI)
REMOTE FP <char> Enable/disable 14575A front panel interface (ON or OFF)
ROM <char> Firmware revision number
SN: <char> Unit serial number
Press to place the dc source into a previously stored state. You can recall up to 4
previously stored states (0 through 3).
Pressing these keys toggles the display between output 1 and output 2.
Display Measurement
1
<reading>V <reading>A Measures output channel 1
2
<reading>V <reading>A Measures output channel 2
Press to display the system error codes stored in the SCPI error queue. This
action also clears the queue. If there is no error in the queue, 0 is displayed.
Press to store an existing dc source state in non-volatile memory. The
parameters saved are listed under *SAV as described in chapter 8. You can save
up to 4 states (0 through 3).
Notes:
value = a numeric value char = a character string parameter
Use and to scroll through the command list.
Use and to scroll through the parameter list.
Shift
Local
Address
Recall
Channel Shift
Error
Shift
Save Shift
( '
# &