Filter
Top Products
B - Performance, Calibration, and Configuration
162
The Configuration function consists of the following menu commands.
Press this key to access the calibration menu.
Simultaneously press these keys to access the configuration menu.
Display Command Function
CFG EXIT Exits the configuration menu and returns to meter mode. Also
exits calibration mode. Changes not previously saved are lost.
CFG:FACTORY Returns the *RST state to the factory default settings.
CFG:COMP <char> Sets the output compensation mode.
CFG:COUP <char> Sets the output coupling mode.
CFG:RELAY1<char> Sets the output 1 relay mode (Option 521 units only).
CFG:RELAY2<char> Sets the output 2 relay mode (Option 521 units only).
CFG:OVP <char> Sets the overvoltage protection mode.
CFG:SAVE Stores the current settings in nonvolatile RAM.
CFG:UNDO Cancels any changes that have been made but not yet saved.
Notes:
char = a character string parameter
Use and to scroll through the menu commands.
Use and to scroll through the menu parameters.
Once the configuration function is started, the front panel will remain in the configuration mode. No
other functions can be accessed from the keypad. To exit the configuration function, the CFG:EXIT
command must be executed. Each configuration command is only executed after the Enter key is
pressed. An “OKAY” message is displayed to indicate that an action has been taken. When the
configuration parameters are changed, they are not immediately stored into non-volatile memory. To
store the change into non-volatile memory, the CFG:SAVE command must be executed
Note that the unit is put into the present *RST state upon entering and exiting the configuration function.
Cal Shift
Recall Local
( '
# &