Filter
Top Products
Installing System Components 121
8
Depress the latch and lift the PIB off the chassis hooks. See Figure 3-27.
9
Remove the PIB from the chassis.
Installing the Power Interposer Board
1
Position the Power Interposer board above the chassis hooks. See
Figure 3-27.
2
Press down on the Power Interposer board until the latch snaps.
3
Connect the SATA PLANAR connector to the Power Interposer board.
4
Connect the PLANAR connector to the Power Interposer board.
5
Connect the control panel connector.
6
Install the system board. See "Installing the System Board" on page 124.
7
Install the SAS backplane. See "Installing the SAS Backplane (2.5" Hard
Drives)" on page 119.
8
Install the optical drive. See "Installing the Optical Drive" on page 89.