Filter
Top Products
43
In-Call Options
Once you initiate a cal, you will
see three onscreen options.
•
End call
( ) to end the
current call. (Touch and drag to the
right.)
•
Speaker
( ) to route the
device’s audio through the speaker
(On) or through the earpiece (Off).
(Touch and drag to the left.)
•
Dialpad
( ) to enter dial
tones using the onscreen dialpad.
(Touch and drag up.)
To see additional options,
tap .
•
Show/Hide dialpad
to toggle the appearance of the onscreen
dialpad.
•
Add call
to initiate a 3-way call (page 42). This can take up to 20
seconds to become available.
•
Merge calls
to join two currently active calls (conference).
•
Swap calls
to answer a second call when call waiting
is activated.
•
End call
to end the current call.
•
Mute/Unmute
to mute the microphone during an active call. Tap
again to unmute the microphone.
Note:
If Mute is activated, the speaker mode is deactivated.
•
Speaker
to route the device audio through the speaker (
On
) or
through the earpiece (
Off
).
–
Activate
Speaker
to route the device audio through the speaker. You
can adjust the speaker volume using the volume buttons.
–
Deactivate
Speaker
to use the device earpiece.
Note:
Because of higher volume levels, do not place the device near your
ear during speakerphone use.
•
Bluetooth
to route the device audio through a connected Bluetooth
headset (
On
) or through the speaker (
Off
). See “Bluetooth” on
page 108.
To route the current call back to the device, tap
Headset
to
temporarily use the device. Tap
Bluetooth
to route the call back to
the connected Bluetooth headset.
–
When the call is routed to a Bluetooth headset, the current call area
shows the
Bluetooth
call icon ( ).
–
When Bluetooth or the Bluetooth headset is turned off, the call is routed
through either the earpiece or speaker and shows ( ).
SCH-M828UM.book Page 43 Friday, August 12, 2011 5:03 PM