Filter
Top Products
6: Basic Parameters
SLC™ 8000 Advanced Console Manager User Guide 61
DNS Servers
DHCP-Acquired DNS Servers
TCP Keepalive Parameters
3. To save your entries, click the Apply button. Apply makes the changes immediately and
saves them so they will be there when the SLC 8000 advanced console manager is rebooted.
Ethernet Counters
The Network > Network Settings page displays statistics for each of the SLC Ethernet ports since
boot-up. The system automatically updates them.
Note: For Ethernet statistics for a smaller time period, use the diag perfstat
command.
Network Commands
The following CLI commands correspond to the web page entries described above.
To configure Ethernet port 1 or 2:
set network port <1|2> <parameters>
Parameters
mode <auto|10mbit-half|100mbit-half|
10mbit-full|100mbit-full|1000mbit-full>
state <dhcp|bootp|static|disable>
[ipaddr <IP Address> mask <Mask>]
[ipv6addr <IP v6 Address|Prefix>]
To configure up to three DNS servers:
set network dns <1|2|3> ipaddr <IP Address>
#1 - #3 Configure up to three name servers. #1 is required if you choose to configure DNS
(Domain Name Server) servers.
The first three DNS servers acquired via DHCP through Eth1 and/or Eth2 display
automatically.
#1 - #3 Displays the IP address of the name servers if automatically assigned by DHCP.
Start Probes Number of seconds the SLC unit waits after the last transmission before sending the
first probe to determine whether a TCP session is still alive. The default is 600
seconds (10 minutes).
Number of Probes Number of probes the SLC 8000 advanced console manager sends before closing a
session. The default is 5.
Interval The number of seconds the SLC unit waits between probes. The default is 60
seconds.