Filter
Top Products
Software-based
Configuration
This section describes basic procedures for setting up the MLC using the MLC 60 Series
Windows-based configuration program. The following topics are covered:
• About the MLC Configuration Program
• Installing the Configuration Software
• Starting the Configuration Software
• Obtaining Device Drivers
For more detailed descriptions and additional configuration procedures, see the
configuration program help file.
About the MLC Configuration Program
An MLC controller must be configured in order for it to be able to control other devices.
The Extron MLC 60 Series Configuration Program is used to set up the MLC front panel
buttons and rear panel ports and to update firmware. Using this software, you can create
configurations on your computer for your MLC and then upload them to the computer via
the MLC USB or Host/Config serial port. (The MLC does not have to be connected to the
computer while you are creating the configurations.) See the “Features, Installation, and
Operation”section for pin assignments and other details on the configuration ports, and
the configuration software help file to create and upload the configurations.
NOTE: Extron recommends configuring and controlling the MLC via the USB port.
This port can supply power to the MLC during the configuration process.
Computer System Requirements
The minimum system requirements for the computer on which you install the MLC
configuration program include:
• Intel Pentium III 1-GHz processor
• Microsoft Windows XP SP2 (32 bit) or Windows 7 (64 bit)
• Microsoft.NET Framework 2.0
• 512 MB of RAM
• 50 MB of available hard disk space
MLC 60 Series MediaLink Controllers • Software-based Configuration 41