Filter
Top Products
Mounting an MLC 64 RS VC D to a Decora Mounting Bracket
A two-gang Decora mounting bracket is provided with the MLC 64. To mount the MLC 64
to this type of bracket:
1. Cut a hole in the mounting surface large enough to accommodate the provided
two-gang mounting bracket.
2. Insert the mounting bracket into the hole.
3. Turn the two screws on the bracket so that the locking arms rotate behind the
mounting surface until they clamp securely to it. Do not overtighten.
4. Run the cables through the mounting bracket and attach them.
5. Place the MLC 64 and the volume control module side-by-side onto the bracket so
that the centers of the oval screw holes at the top and bottom of both module boards
line up with the four holes on the bracket.
6. Insert the four provided silver, rounded Phillips head screws through the oval holes
in the two MLC boards and then the round holes in the Decora mounting bracket
behind, and tighten the screws.
7. Place the wallplate over the two MLC modules. The front panels should protrude
through the slots in the wallplate, while the two boards fit into the recessed area on
the back side of the wallplate.
8. Fasten the wallplate onto the MLC boards, using the four provided black or white
screws in the holes at the top and bottom of the wallplate.
Wallplate
MLC 64 VC D
Wall Mouting
Bracket
Wall
4.06"
3.75"
MUTE
VOLUME
DISPLAY
OFF
ON
AUX
LAPTOP
PC
VIDEO
Figure 40. Mounting an MLC 64 D to a Two-gang Decora Mounting Bracket
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation 34