Filter
Top Products
5–Fibre Channel Noninteractive Commands
-q (View or Set Target Link Speed)
SN0054667-00 C 5-31
-q
(View or Set Target Link Speed)
Issue the following command to view the link speed of all targets attached to one
adapter or all adapters:
# qaucli -pr fc -q (<hba instance> | <hba wwpn> | <all>)
[-targets
| -t ]
Where:
To view the link speed of a specific target attached to an adapter, issue the
following command:
# qaucli -pr fc -q (<hba instance> | <hba wwpn> | <target wwpn>
Where:
To set the link speed of all targets attached to one adapter or all adapters to the
designated speed, issue the following command:
# qaucli -pr fc -q (<hba instance> | <hba wwpn> | <all>) <-targets
| -t ><speed>
Where:
NOTE:
The -q option is supported only on 4Gb adapters.
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
all = Reports link speed for all targets on all adapters in the system
-targets = All targets
-t = All targets
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
target wwpn = World wide port name of the target
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
all = Reports link speed for all targets on all adapters in the system
-targets = All targets
-t = All targets
speed = Link speed (