Filter
Top Products
6–iSCSI Noninteractive Commands
-dc (Display Destination Cache [IPv6 only])
6-6 SN0054667-00 C
-dc
(Display Destination Cache [IPv6 only])
The IPv6 destination cache contains the IP address, next-hop IP address, and
path MTU information about both local and remote destinations. For multicast and
on-link unicast destinations, the next-hop IP address always matches the
destination IP address. For unicast destinations that are off-link, the next-hop IP
address is the IP address of the router.
To display the destination cache, issue the -dc command as follows:
-dc <hba_port_inst>
-dce
To display the connection error logs for up to 100 latest connections, issue the
-dce command as follows:
-dce <hba_port_inst> <target_id> <filename>
If
<hba_port_inst>
and
<target_id>
are not specified, all entries for all adapter
ports are displayed. If
<filename>
is specified, then the log is written to that file.
-defbidi
To add a default BIDI CHAP entry to the specified hba_port_inst, issue the
-defbidi command as follows:
-defbidi <hba_port_inst> <chap_secret>
Where <chap_secret> is the CHAP secret.
The adapter is reset after this command is issued.
-delchap
(Delete a CHAP Entry)
To delete the specified CHAP entry, issue the -delchap command as follows:
-delchap <hba_port_inst> <CHAP>
Issuing this command resets the adapter.
-df
To view the firmware properties, issue the -df command as follows:
-df <hba_port_inst>
QConvergeConsole CLI displays information about the adapter: model, serial
number, port number, iSCSI name, alias, IP address, instance number, and the
following firmware information:
FW information for instance
FW version