Filter
Top Products
5–Fibre Channel Noninteractive Commands
-fg (Show Driver Settings)
5-12 SN0054667-00 C
3. Issue the qaucli -pr fc command with the -f option (input from
command file):
# qaucli -pr fc -f setadapter0.txt
# qaucli -pr fc -f <file name>
QConvergeConsole CLI specifies command line input from file.
-fg
(Show Driver Settings)
To show the driver settings, issue the following command:
# qaucli -pr fc -fg (<hba instance> | <hba wwpn>) (view | info)
Where:
-fs
(Configure Driver Settings)
Type the following command to configure the driver settings:
# qaucli -pr fc -fs (<hba instance> | <hba wwpn>) {(<param name> |
<param alias>) <param value>}
Where:
The pairs <param name> <param value> and <param alias> <param value> can
be repeated to set multiple parameters in a single command.
Table 5-4 lists the driver configuration parameter names and aliases.
NOTE:
The -fg option is valid only in noninteractive mode.
The -fg option is not supported for Linux/Solaris.
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
hba instance = Adapter instance number of an adapter port (use -g
command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameters
param alias = Alias of the parameters
param value = New value of the parameters