Filter
Top Products
5–Fibre Channel Noninteractive Commands
-tb (Target Beacon On/Off)
5-34 SN0054667-00 C
To show specific target information for a specific target on an adapter, issue the
following command:
# qaucli -pr fc -t (<hba instance> | <hba wwpn>) (<target wwpn> |
<target port id>)
Where:
To show the target information on all adapters, issue the following command:
-t [<all>]
To show the target information on a specific adapter, issue the following
command:
-t (<hba instance> | <hba wwpn>)
To show the target information for a specific target on a specific adapter, issue the
following command:
-t (<hba instance> | <hba wwpn>) (<target wwpn> | <target port id>)
iiDMA (intelligent interleaved direct memory access) settings include:
—targets | –t applies to all targets.
<speed> indicates the supported intelligent interleave factor: 1, 2, 4, or
8Gbps.
-tb
(Target Beacon On/Off)
To start or stop flashing a target’s LED, issue the following command:
# qaucli -pr fc -tb (<hba instance> | <hba wwpn>) (<target wwpn>)
(<0 | ON> | <1 | PRESET>)
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
target wwpn = World wide port name of the target
target port id = Port ID of the target
NOTE:
The <0 | ON> option flashes the LED until interrupted.
The <1 | PRESET> option flashes the LED 12 times.
This feature is supported only on JBOD (“just a bunch of disks”) devices.