Filter
Top Products
5–Fibre Channel Noninteractive Commands
-gs (Show HBA Statistics)
SN0054667-00 C 5-13
The following restrictions apply:
Under Linux, this feature is disabled if you are using the IOCTL or sysfs
(inbox) driver.
Under Mac OS
®
, the BindWWPN and BindPortID parameters are not
changeable; Mac OS supports only the BindWWPN parameter.
-gs
(Show HBA Statistics)
To view the adapter statistics, issue the following command:
# qaucli -pr fc -gs (<hba instance> | <hba wwpn>) [(<param name> |
<param alias>) <param value>]
Where:
Table 5-5 lists the adapter statistics parameter names, aliases, and values.
Table 5-4. Driver Settings Parameters
Description
Parameter Name
<param name>
Alias
<param
alias>
Value
a
<param
value>
a
0 = Disabled, 1 = Enabled
Persistently bound target(s) only PersistentOnly PO 0, 1
Present persistently bound tar-
get(s) plus any new target(s) with
driver default
PersistentPlusNew PN 0, 1
Present targets with driver default
NewOnly
b
b
Driver parameter NewOnly (NO) is supported only with the failover driver. If you select a QLA22xx
adapter, all QLA22xx adapters on the host will use the same settings. If you select a 23xx adapter,
all 2G/4G adapters on the host will also use the same settings.
NO 0, 1
Bind devices by WWPN BindWWPN BW 0, 1
Bind devices by port ID BindPortID BP 0, 1
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameter (see table 4-7)
param alias = Alias of the parameter (see table 4-7)
param value = New value of the parameter (see table 4-7)