Filter
Top Products
6–iSCSI Noninteractive Commands
-pdt
6-20 SN0054667-00 C
This command is not active for the PPC.
For information on secondary boot code, see “-sbootcode (Set Secondary Boot
Target Information)” on page 6-24.
-pdt
To disable a target, issue the -pdt command as follows:
-pdt <hba_port_inst> <targetId>
-pet
To enable a target, issue the -pet command as follows:
-pet <hba_port_inst> <targetId>
-pinfo
(Port Information)
To view port information for the specified adapter, issue the -pinfo command as
follows:
-pinfo <hba_port_inst>
-ping
(Ping Target)
To ping the target device, issue the -ping command as follows:
-ping <hba_port_inst> <IP Address> <Ping Count> <Packet size>
<IPv6 source address>
The following provides the IPv6 source address values:
Where:
0 = Do not care
1 = Local link
2 = Address 0
3 = Address 1
hba_port_inst = The adapter port that sends the ping
IP Address = The IP address to ping
Ping Count =
The number of ping packets you want (1–[2
31
]).
Packet Size = The size of the ping packet 0–64kB
IPv6 Source Address = Origin device