Filter
Top Products
6–iSCSI Noninteractive Commands
-dtrem (Remove Discovered Target)
SN0054667-00 C 6-9
-dtrem
(Remove Discovered Target)
To remove a nonpersistent discovered target, issue the -dtrem command as
follows:
-dtrem <hba_port_inst> <target_instance>
To obtain the target instance, use the command “-dtdsp (Display Discovered
Targets)” on page 6-7.
-dtrema
(Remove Discovered Target)
To remove all nonpersistent discovered targets, issue the -dtrema command as
follows:
-dtrema <hba_port_inst>
-dumpcore
(Retrieve FW Coredump Record)
To dump the RAM memory to a file name of your choice, issue the -dumpcore
command as follows:
-dumpcore <hba_port_inst> <file name>
-dumpnvram
(Retrieve FW Flash & NVRAM Record)
To dump the NVRAM to a file name of your choice, issue the -dumpnvram
command as follows:
-dumpnvram <hba_port_inst> <file name>
-dv
To see the version of the iSCSI adapter driver(s) installed, issue the -dv
command as follows.
-dv
-edchap
(Edit a CHAP Entry)
To change the value of the specified CHAP entry, issue the -edchap command
as follows:
-edchap <hba_port_inst> <CHAP> <Parameter> | <Parameter Alias>
<Value> [<Parameter> | <Parameter Alias> <Value>…]
You can repeat the <Parameter>|<Parameter Alias> <Value> parameter
pair to change multiple values as shown in Table 6-2. Press
ENTER
after each
entry.