Filter
Top Products
10–Converged Network Adapter Interactive Commands
CNA FCoE Configuration
SN0054667-00 C 10-27
Configure HBA Parameters
From the HBA Parameters menu, select the Configure HBA Parameters option
to open the Configure Parameters Menu. Select the parameter option and change
the value. Refer to Table 5-9 for details about these parameters and their values.
For example:
1: Connection Options
2: Data Rate
3: Frame Size
4: Hard Loop ID
5: Loop Reset Delay (seconds)
6: Enable BIOS
7: Enable HBA Hard Loop ID
8: Enable Fibre Channel Tape Support
9: Operation Mode
10: Interrupt Delay Timer (100ms)
11: Execution Throttle
12: Login Retry Count
13: Port Down Retry Count
14: Enable LIP Full Login
15: Link Down Timeout (seconds)
16: Enable Target Reset
17: LUNs per Target
18: Enable Receive Out Of Order Frame
19: Commit Changes
20: Abort Changes
Restore Defaults
From the HBA Parameters menu, select the Restore Defaults to restore adapter
parameters to their factory default values.
CAUTION!
Restoring the adapter parameters can make the adapter inoperable.
When restoring NVRAM parameters, the current BIOS device settings
are also cleared.