Filter
Top Products
Assembly and Use
©
2014 DJI. All Rights Reserved.
15
Camera LED Indicator
Camera LED Indicator lights up after the ight battery is powered on. It provides information on the working status of the
camera.
Camera LED Indicator Wi-Fi status Camera status
Solid OFF Power On; Idle
Slow Blink (0.2s on, 1.8s off) ON Idle
Blink (0.1s on, 0.3s off, 0.1s on, 1.8s off) ON Micro-SD card connected to PC
Fast Blink (0.1s on, 0.3s off) ON Synchronizing
Solid OFF Recording
Blink Once (0.2s on, 0.3s off) ON / OFF Taking a single picture.
Blink 3 Times(0.1s on, 0.1s off) ON / OFF Taking 3 or 5 photos per shot
Fast Blink (0.1s on, 0.3s off) ON / OFF Firmware Upgrading
(0.2s green, 1.8s yellow) ON Recording
Solid ON / OFF Critical error
Slow Blink (0.2s on, 1.8s off) ON / OFF CMOS sensor error
Blink Once (0.2s on, 0.3s off) ON / OFF Operation failed
Blink 3 Times(0.1s on, 0.1s off) ON / OFF Micro-SD card error
Fast Blink (0.1s on, 0.3s off) ON / OFF Upgrade error
Fast Blink (0.1s on, 0.3s off) ON / OFF Overheated Camera
4 Attaching the Propellers
Always use original 9-inch propellers, classied by the color of each central nut.
4.1 Introduction
Propellers Grey Nut (9443) Black Nut (9443 R)
Diagram
Assembly Location Attach to motor without black dot. Attach to motor with black dot.
Fastening/
Un-fastening
Instructions
Lock: Tighten propeller in this direction.
Unlock: Loosen propeller in this direction.
4.2 Assembly
(1) (Figure 20) Remove warning cards from motors after you have read them.
(2) (Figure 21) Spin grey marked propellers clockwise onto unmarked motors and black marked propellers anti-
clockwise for black marked motors.
Figure 20 Figure 21
Attaching the Propellers