Filter
Top Products
Programming Commands
Programming Commands
Programming Commands
This chapter documents programming the eye-diagram analyzer.
Note You will find the preview feature discussed in this chapter very useful. It
displays the programming command corresponding to the response received
when most softkeys are pressed.
You will find information on the following commands in this chapter.
• ALIGN 4-4
• BIT 4-5
• CLEAR 4-5
• DEFAULT 4-6
• DELAY 4-7
• DIAGRAM 4-7
• EXTIN 4-8
• MARGIN 4-9
• MARMSK 4-9
• MEAS 4-10
• PERSIST 4-11
• QUIT 4-12