Filter
Top Products
Eye-Diagram Analyzer Reference
Creating Copies of the Display
4 Select the print option by pressing:
←, copy options, COPY IS PRT/PLT PRT
5 Create the print by pressing:
USER, PRINT
To Create a Plot Hard copies can be produced on an Hewlett-Packard plotter if the eye-dia-
gram analyzer is in pattern mode. Plots cannot be produced in eye or eyeline
modes.
1 Connect the plotter to the display via an GPIB cable.
Be sure to connect the GPIB to the display’s connector, not to the connector
on the 70820A microwave transition analyzer module.
2 The first time the plotter is used, enter the plotter type and address by
pressing:
DISPLAY, Hard Copy, plotter address
HP-IB TLK/LSN to configure the plotter in talk/listen mode on the GPIB.
HP-IB L ONLY to configure the plotter in listen only mode on the GPIB.
To configure the plotter via the HP-MSIB, use the HP-MSIB COLUMN and HP-
MSIB ROW softkeys to enter the plotter address.
3 To select the type of plotter used, press:
←, plotter config
Use the softkeys along the right side of the display to select the plotter type.
4 Select the plotter option by pressing:
←, copy options, COPY IS PRT/PLT PLT
5 Create the plot by pressing:
USER, PLOT