Filter
Top Products
Eye-Diagram Analyzer Reference
Agilent 70820A Calibration
The Calibration Menu
Turning Off RF Correction
The microwave transition analyzer module applies RF correction factors to all
measurements. These correction factors are loaded into nonvolatile memory
at the factory . You can prevent the use of RF correction factors during mea-
surements.
Note Eyeline and pattern modes are required. RF corrections can only be applied in
eyeline and pattern modes. RF corrections must be off in eye mode.
To Turn Off RF
Correction
Turn off RF correction by pressing:
MENU, page 1 of 2, Calib, RF corr ON|OFF OFF