Filter
Top Products
3-10 (E)
HDCU-950 IMM
* Slot-6 Diag *
Front: EN
PLD V1.00 Config Done
Mode Normal
Rear: VDA
1
2
3
* Slot-6 Diag *
Front: RC
Squeeze
PLD V1.00 Config Done
Mode Normal
Rear: DIF
Output-A SD SDI
Output-B SD SDI
2
1
3
5
4
6
3-3. Character Display Function
Page 13-1
Slot-6 Diag Dispaly
Displays the details of self-diagnosis of the EN-145 board
when the EN-145 board is mounted in the sixth slot (right
most) from the left of the front side of the unit.
No. Contents
1 Displays the state of the PLD (IC310 on the EN-145
board) version and PLD. (Config Done/Config NG)
Config Done : PLD (IC310 on the EN-145 board)
started correctly.
Config NG : PLD (IC310 on the EN-145 board) did not
start correctly.
2 State of the operation mode on the EN-145 board
(Normal/Test)
3 Displays when the VDA-61 board is mounted in the rear
correctly.
Page 13-2
Slot-6 Diag Dispaly
Displays the details of self-diagnosis of the RC-91 board
when the RC-91 board is mounted in the sixth slot (right
most) from the left of the front side of the unit.
No. Contents
1 Displays the aspect ratio conversion mode during down-
conversion.
2 Displays the state of the PLD (IC301 and IC504 on the
RC-91 board) version and PLD. (Config Done/Config NG)
Config Done : PLD (IC301 and IC504 on the RC-91
board) started correctly.
Config NG : PLD (IC301 and IC504 on the RC-91
board) did not start correctly.
3 State of the operation mode on the RC-91 board (Normal/
Test)
4 Displays when the DIF-124 board is installed in the rear
correctly.
5 Displays the type of signal that is output from the SD SDI
OUT1 connector on the rear panel. (SD SDI/VBS)
*10
6 Displays the type of signal that is output from the SD SDI
OUT2 connector on the rear panel. (SD SDI/VBS/MONI
SDI)
*11
*10 :When the HKCU-951 is installed, set the switch with S103 on the EN-
145 board. When the HKCU-951 is not installed, the switch is fixed to
SD SDI.
For details, refer to Section 1-6-7. “Setting of Switches on Boards _
EN-145 Board”.
*11 :When S10-1 on the RC-91 board and the HKCU-951 are installed, set
the switch with S104 on the EN-145 board.
For details, refer to Sections 1-6-6 and 1-6-7. “Setting of Switches on
Boards _ RC-91 Board and EN-145 Board”.