Filter
Top Products
2-20 (E)
HDCU-950 IMM
Press the SEQ button of the WAVEFORM MONITOR
button (or the MONITOR SELECT button) of the MSU-
700A/750, RCP-740/741, etc., to output the waveform
monitor control signal of the unit, synchronizing with the
output signal of the WF OUT connector.
n
The control method of the sequential mode depends on the
waveform monitor used. If required, change the polarity of
the control from the setting of switch S301 (SEQ) on the
RC-91 board.
If adjustment is not possible even after the polarity is
changed, perform the adjustment on the waveform monitor
side.
A B
2-5. Video Signal System