Filter
Top Products
1-13 (E)
HDCU-950 IMM
. S15 (MIC DELAY)
This switch is used to match the amount of delay of MIC
and AES/EBU format audio signal with the video signal.
About 5 msec. is delayed per one step.
Example) :7 : 1 FRAME DELAY (30 FRAME/SEC)
8 : 1 FRAME DELAY (25 FRAME/SEC)
Factory setting : 0
. S16-1 to 8
Factory use only
Factory setting : All OFF
. S100 (R TALLY POWER/CONTACT)
. S102 (R TALLY POWER/TTL)
Set these switches according to the signal standard of the
R TALLY signal to be input in the INCOM/TALLY/
PGM connector on the rear panel. Refer to the following
table for the relation between signals and switch setups.
Factory setting : CONTACT (S100)
TTL (S102)
. S101 (G TALLY POWER/CONTACT)
. S103 (G TALLY POWER/TTL)
Set these switches according to the signal standard of the
G TALLY signal to be input in the INCOM/TALLY/
PGM connector on the rear panel. Refer to the following
table for the relation between signals and switch setups.
Factory setting : CONTACT (S101)
TTL (S103)
Setting the tally system
Red tally Green tally
Switch S100 S102 S101 S103
Signal POWER/ POWER/ POWER/ POWER/
standard CONTACT TTL CONTACT TTL
Contact CONTACT _ CONTACT _
supply
24 V voltage POWER POWER POWER POWER
supply
5 V voltage POWER TTL POWER TTL
supply
. S500 (PGM 1 SEL)
Set the input signal level of the PGM (program audio)
CH-1 to either 0 dBu or _20 dBu.
Factory setting : 0 dBu
. S501 (PGM 2 SEL)
Set the input signal level of the PGM (program audio)
CH-2 to either 0 dBu or _20 dBu.
Factory setting : 0 dBu
. 502 (MIC 2 OUT LEVEL)
Set the AUDIO signal level of the MIC-2 connector on
the rear panel to either 0 dBu or _20 dBu.
Factory setting : 0 dBu
. S503 (MIC 1 OUT LEVEL)
Set the AUDIO signal level of the MIC-1 connector on
the rear panel to either 0 dBu or _20 dBu.
Factory setting : 0 dBu
. S610 (PROD RTS/CLEAR)
. S611 (PROD INCOM ENG SELECT)
Selects the intercom system of the producer line.
Factory setting : 4W (S611)
RTS (S610)
S611 S610
4-wire system 4W _
RTS system RTS RTS
Clear-Com system RTS CC
. S710 (ENG RTS/CLEAR)
. S711 (ENG INCOM ENG SELECT)
Selects the intercom system of the engineer line.
Factory setting : 4W (S711)
RTS (S710)
S711 S710
4-wire system 4W _
RTS system RTS RTS
Clear-Com system RTS CC
1-6. Setting of Switches on Boards