Filter
Top Products
3-7 (E)
HDCU-950 IMM
* AT Diag *
System Frequency 1.001
CHU Format Setting
Remote 1080/59.94I
Ref.H Phase SD Local
HD-SD DLY 90H
Marker Setting Remote
CCU Mode Normal
1
2
3
4
5
6
* AVP Diag *
PLD V1.00 Confing Done
AVP Mode Normal
1
2
3-3. Character Display Function
Page 8
AT Diag Display
Displays the details of self-diagnosis of the AT-149 board
of the unit.
No. Contents
1 Display of system frequency coefficient (1.001/1.000)
*4
2 Display of Remote/Local state of camera format setting
and setup format
3 Setting of the reference signal and display of the
Removal/Local state (SD Local/SD Remote/HD Local/HD
Remote)
4 Setting state of delay amount (setting of S417 on the AT-
149 board) when converting the format from the HD
signal to SD signal (1 Frame/90H)
*4
5 Aspect marker added to the monitor signal and state of
modulation chroma removal (setting of S408 on the AT-
149 board) (Local/Remote)
*4
6 State of the operation mode (setting of S424 on the AT-
149 board)
*5
of the AT-141 board (Normal/Test)
*4 : For details, refer to Section 1-6-1. “Setting of Switches on Boards _ AT-
149 Board”.
*5 : Set S424 to all OFF so that it is set to normal mode.
Page 9
AVP Diag Display
Displays the details of self-diagnosis of the AVP-4 board
of the unit.
No. Contents
1 Displays the version of the PLD (IC300 on the AVP-4
board) and the state of the PLD. (Config Done/Config
NG)
Config Done: PLD (IC300 on the AVP-4 board) started
correctly.
Config NG: PLD (IC300 on the AVP-4 board) did not
start correctly.
2 State of the operation mode of the AVP-4 board (Normal/
Test)