Filter
Top Products
1-17 (E)
HDCU-950 IMM
. S605 (RETURN SET)
Sets the format of the return signal to be input to the
RET1 to 3 connectors on the rear panel.
HD : Sets the RET1 to 3 to the HD-SDI.
SD : Sets the RET1 to 3 to SD. (Depends on the
setting of S601, S603 and S604 on the DTX-1
board.)
REM :Sets the format of each return signal from RM/
MSU, etc. connected outside.
Factory setting : REM
. S606 (RET FC SET)
Sets the frame conversion type of the return signal to be
input to the RET1 to 3 and RET4 (PROMPTER) connec-
tors on the rear panel.
S606-1, -2 : RET1
S606-3, -4 : RET2
S606-5, -6 : RET3
S606-7, -8 : RET4 (PROMPTER)
S606-1, -3, S606-2, -4, Type of frame conversion
-5, -7 -6, -8
ON ON THROUGH :
Frame conversion is not
performed.
OFF ON A (24PsF conversion) :
When the camera side is
24PsF, the forced-reverse
conversion is performed.
(Conversion to reconstruct
24PsF)
ON OFF B (48i conversion) :
When the camera side is
24PsF, the forced-reverse
conversion is performed.
(Conversion to 48i format
by simple skipping)
OFF OFF AUTO :
Depends on the setting of
S1-1 on the FC-88 board.
Factory setting : All OFF
1-6. Setting of Switches on Boards
. S607 (RETURN MODE)
Perform setting of the return signal.
Factory setting : All OFF
-1 (RET-DLY)
Sets the SD return signal and the delay amount of the
phase during up-convert.
ON : Up-convert in the least time
OFF : 1-field delays at maximum.
-2 (RET4-VBS)
Sets whether the PROMPTER connecter on the rear
panel is used or not as RET4 (VBS input).
ON : Uses it as PROMPTER input.
OFF : Uses it as RETURN4 (VBS input).
-3 to 8
Factory use only
. S608-1 to 8
Factory use only
Factory setting : All OFF
. S610 (FC SEQUENCE)
Phase at the conversion cycle can be changed during the
frame frequency conversion of the return signal. (Timing
to delete the field can be freely selected during conver-
sion of 60i → 48i and 50i → 48i.)
Factory setting : 0