OpenVMS Software Installation and Upgrade Release Notes
1.15 Remove TIE Kit Before Upgrade
1.15 Remove TIE Kit Before Upgrade
V8.2-1
The Translated Image Environment (TIE) has been integrated into OpenVMS
Integrity servers Version 8.2–1. Refer to the HP OpenVMS Systems Migration
Software web site for further information.
http://www.hp.com/go/openvms/products/omsais
If you have installed any version of the TIE PCSI kit (HP-I64VMS-TIE) on
OpenVMS Integrity servers Version 8.2 or Version 8.2-1, you must manually
remove the TIE kit before you upgrade to OpenVMS Integrity servers Version 8.3.
Use the following command to remove the TIE product kit:
$ PRODUCT REMOVE TIE
Do not install the TIE product kit, HP I64VMS TIE V1.0, on OpenVMS Integrity
servers Version 8.2-1 or later.
1.16 Installation Failure of Layered Products on Alternate Devices
or Directories
V8.3
By default the
PRODUCT INSTALL
command installs a layered product on the
system device in the
SYS$COMMON
directory tree. If you choose to install a layered
product to an alternate device or directory using the
/DESTINATION=dev:[dir]
qualifier (or by defining the logical name
PCSI$DESTINATION
), the installation may
fail with an error message stating that one of the following files cannot be found:
[SYSLIB]DCLTABLES.EXE
,
[SYSHLP]HELPLIB.HLB
,or
[SYSLIB]STARLET*.*
. If this
happens, answer YES to the question, "Do you want to terminate? [YES]," and
then retry the installation using the
/NORECOVERY_MODE
qualifier.
1–14 OpenVMS Software Installation and Upgrade Release Notes
