AdeptSix 300CR Robot Instruction Handbook, Rev. A 33
Robot Installation 3
3.1 Safety Guard Installation
To ensure safety, make sure to install safety guards, which prevent unforeseen accidents
with personnel and damage to equipment. The following standard is noted below for
your information and guidance.
Safety Standard Information (ISO10218)
Responsibility for Safeguarding
The user of a manipulator or robot system shall ensure that safeguards are provided and
used in accordance with Sections 6, 7, and 8 of this standard. The means and degree of
safeguarding, including any redundancies, shall correspond directly to the type and level
of hazard presented by the robot system consistent with the robot application.
Safeguarding may include but not be limited to safeguarding devices, barriers, interlock
barriers, perimeter guarding, awareness barriers, and awareness signals.
WARNING: Install the safety guards. Failure to observe
this warning may result in injury or damage.
WARNING: Install the robot in a location where the fully
extended arm and end-of-arm tooling will not reach the
wall, safety guards, or controller. Failure to observe this
warning may result in injury or damage.
WARNING: Do not start the robot or even turn on the
power before it is firmly anchored. The robot may
overturn and cause injury or damage.
