Intended Use of the Robots
AdeptSix 300CR Robot Instruction Handbook, Rev. A 25
The standard AdeptSix 300 robot control system meets or exceeds the requirements
imposed by the EN 954 specified Category 1 level of safety.
2.4 Intended Use of the Robots
The installation and use of Adept products must comply with all safety instructions and
warnings in this manual. Installation and use must also comply with all applicable local
and national requirements and safety standards (see Section 2.8 on page 28).
The AdeptSix 300CR Robot robots are intended for use in parts assembly and material
handling for payloads less than 3 kg. See Chapter 5 for complete information tooling and
payloads.
The Adept controller is a component subassembly of a complete industrial automation
system. The controller subassembly must be installed inside a suitable enclosure. The
controller subassembly must not come into contact with liquids. Additionally, the robot
must not come into contact with liquids.
The Adept equipment is not intended for use in any of the following situations:
• In hazardous (explosive) atmospheres
• In mobile, portable, marine, or aircraft systems
• In life-support systems
• In residential installations
• In situations where the Adept equipment will be subject to extremes of heat or
humidity.
Non-intended use of an AdeptSix 300 robot can:
• Cause injury to personnel
• Damage the robot or other equipment
• Reduce system reliability and performance
All persons that install, commission, operate, or maintain the robot must:
CAUTION: For safety reasons, it is prohibited to make
certain modifications to Adept robots (see Section 2.5).
CAUTION: The instructions for operation, installation, and
maintenance given in this Instruction Handbook must be
strictly observed.
