Filter
Top Products
Operation
5–8 975-0083-01-01
If the System Control Panel is powered off while in Safe mode, it will be
in Safe mode when it is powered up again.
To return to Operating mode:
◆ On the System Settings menu, under Desired Mode, select
“Operating”.
Warnings and Faults
This section describes how fault and warning messages behave, and what
you should do when they appear. For a complete list of System Control
Panel fault and warning messages along with recommended actions to
correct the fault or warning condition, please refer to Chapter 6,
“Troubleshooting”.
Warning messages
Warning messages will appear when the System Control Panel detects a
condition that may eventually affect its continued operation. When a
warning occurs, the System Control Panel will continue operating.
However, you should consult the Troubleshooting chapter to find out
what actions you can take to prevent the warning from escalating into a
fault.
Types There are two types of warning messages: manual and automatic. Each
differs in its behavior and appearance. For a list of System Control Panel
warnings and their associated types, refer to Chapter 6,
“Troubleshooting”.
Important:
The System Control Panel displays fault and warning messages
for all Xanbus-enabled devices in the system. For information about fault and
warnings for other devices, refer to the Troubleshooting chapter in the Owner’s
Guide or Operation Guide for each device.
Figure 5-6
System Control Panel warning message
continue cancel
scp_manual.book Page 8 Wednesday, March 10, 2010 5:03 PM